3M Scotch-Weld PUR Easy 250 Manual Del Usuario página 12

Reloading Applicator (continued)
Cold Cartridge Reload
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges. Use with
any other material may cause
hazardous conditions.
WARNING
!
3M™ Scotch-Weld™ Polyurethane
Reactive (PUR) Easy 250 or 3M™
Scotch-Weld™ Polyurethane Reactive
Adhesive Cartridges should be
preheated or used in 3M™
Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 Adhesive Preheater or
3M™ Scotch-Weld™ (PUR) Easy 250
Adhesive Applicator only. Do not
preheat 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges in ovens
or other heating devices or use in
other applicators. May cause
hazardous conditions.
Caution
!
Avoid contact with hot adhesive,
cartridge, applicator tip, and metal
components. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
10
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
4. Insert adhesive cartridge without puncturing or attaching disposable nozzle into
applicator as shown.
5. Tighten applicator end cap to ensure a positive seal. Allow cartridge to warm for a
minimum of 45 minutes.
6. Remove adhesive cartridge and place on a bench or flat work surface with threaded
nozzle pointing upward. Allow cartridge to stand for approximately 60 seconds.
7. Place a rag or paper towel around or near the nozzle portion of the cartridge.
8. Place a punch or similar tool into the nozzle portion of the cartridge as shown.
Note: If there is a small "burp" of
adhesive, the rag or paper towel will
contain any adhesive and allow for
clean up prior to attaching the
disposable nozzle.
© 3M 2014