Condition 1: No Or Low Adhesive Flow/Audible Air Leak - 3M Scotch-Weld PUR Easy 250 Manual Del Usuario

Condition 1:
No or Low Adhesive Flow/
Audible Air Leak
Caution
!
Avoid contact with hot adhesive,
cartridge, applicator tip, and metal
components. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
© 3M 2014
Perform the following steps until adhesive flow is achieved.
1. Tighten applicator end cap to ensure positive seal. If this does not produce adhesive
flow, proceed to next step.
2. Remove end cap by rotating end cap counterclockwise.
3. Inspect inside of end cap for improperly seated or damaged seal. Reposition or
replace seal if necessary with end cap seal 62-9895-0004-6. If this does not
produce adhesive flow, proceed to next step.
End Cap Seal
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
Pierce Tube
21