Applicator Shutdown - 3M Scotch-Weld PUR Easy 250 Manual Del Usuario

Preheated Cartridge Reload
Caution
!
Avoid contact with hot adhesive,
cartridge, applicator tip, and metal
components. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges. Use with
any other material may cause
hazardous conditions.

Applicator Shutdown

Caution
!
Avoid contact with hot adhesive,
cartridge, applicator tip, and metal
components. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
© 3M 2014
8. Select and install a disposable nozzle (A)
provided with the 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 20 or
3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive onto the cartridge by
turning the nozzle clockwise until the
nozzle base is tight or flush with the
cartridge using the supplied plastic
wrench (B) to aid tightening."
9. Insert adhesive cartridge complete with
disposable nozzle into the applicator
as shown.
10. Tighten applicator end cap to insure a
positive seal by turning clockwise and
follow "Dispensing" procedure for trouble
free operation.
Do not remove cartridge from applicator! Cartridge must remain sealed during
applicator shutdown. Failure to do so will allow moisture to cure the adhesive
in the cartridge and render it unusable.
1. Push on/off switch to "OFF" position. The red
portion of the switch will no longer be visible.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
Important
On Off
On/Off
Switch
15