3M Scotch-Weld PUR Easy 250 Manual Del Usuario página 37

WARNING
!
Disconnect air and electrical power
and make sure applicator has cooled
to room temperature before servicing.
Failure to disconnect air and electrical
power or failure to allow applicator to
cool before servicing may cause
electrical shock or burns. Read
User's Manual before servicing.
© 3M 2014
18. Using a volt/ohm meter to check power cord, place one probe in lower left position
of three pole connector containing black wire. Connect the other probe to the left
side of the electrical plug.
Three Pole
Connector
Move the cord back and forth to insure there is not a partial or intermittent connection.
19. If no or intermittent continuity exists, replace power cord assembly
62-9895-0021-0.
20. If continuity exists place one probe of the volt/ohm meter into lower right position
of three pole connector containing white wire. Connect the other probe to the
neutral side of the electrical plug. Move the cord back and forth to insure there is
not a partial or intermittent connection.
Three Pole
Connector
21. If no or intermittent continuity exists, replace power cord assembly
62-9895-0021-0.
22. If power cord has continuity but unit still does not heat, repeat troubleshooting
steps or contact your local 3M representative.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
35