Troubleshooting - 3M Scotch-Weld PUR Easy 250 Manual Del Usuario

Troubleshooting

WARNING
!
Use only 3M-specified replacement
parts. Use of other replacement parts
may cause hazardous conditions or
damage the applicator.
20
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
This part of the User's Manual is divided into five sections to assist in evaluating
possible problems with your 3M™ Scotch-Weld™ Polyurethane Reactive (PUR)
Easy 250 Adhesive Applicator.
If the applicator is heating refer to:
Condition 1:
No or Low Adhesive Flow/Audible Air Leak
Condition 2:
No or Low Adhesive Flow/No Audible Air Leak
Condition 3:
Nozzle Drip
Condition 4:
Continuous Adhesive Flow
Condition 5:
Slow Adhesive Shut Off
If the applicator will not heat, refer to:
Condition 6:
Applicator Will Not Heat
An applicator diagram and replacement parts list can be found on page 17.
Should your applicator require repair, replacement parts can be ordered from
your local authorized 3M™ Scotch-Weld™ Polyurethane Reactive (PUR)
Easy 250 or 3M™ Scotch-Weld™ Polyurethane Reactive Adhesive distributor.
If, after following these procedures, a problem still exists, contact your local
3M sales representative. For telephone numbers of the nearest 3M location
refer to the back cover of this manual.
Service on this applicator should only be performed by a qualified
electrician or service person.
Important
Page 21
Page 26
Page 30
Page 30
Page 30
Page 30
© 3M 2014