3M Scotch-Weld PUR Easy 250 Manual Del Usuario página 13

Cold Cartridge Reload
WARNING
!
3M™ Scotch-Weld™ Polyurethane
Reactive (PUR) Easy 250 or 3M™
Scotch-Weld™ Polyurethane Reactive
Adhesive Cartridges should be
preheated or used in 3M™
Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 Adhesive Preheater or
3M™ Scotch-Weld™ (PUR) Easy 250
Adhesive Applicator only. Do not
preheat 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges in ovens
or other heating devices or use in
other applicators. May cause
hazardous conditions.
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges. Use with
any other material may cause
hazardous conditions.
© 3M 2014
9. Tap the punch handle using a hammer, mallet or similar instrument until the
front aluminum seal of the cartridge has been pierced.
10. Select and install a disposable nozzle (A) provided with the 3M™
Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive or 3M™
Scotch-Weld™ Polyurethane Reactive Adhesive onto the cartridge by turning
the nozzle clockwise until the nozzle base is tight or flush with the cartridge
using the supplied plastic wrench (B) to aid tightening.
11. Insert adhesive cartridge, complete with disposable nozzle into the applicator
as shown.
12. Adjust the Shroud: With a 3M™ Scotch-Weld™ Polyurethane Reactive (PUR)
Easy 250 or 3M™ Scotch-Weld™ Polyurethane Reactive Adhesive cartridge
and Disposable Nozzle loaded in the applicator, insert Nozzle Shroud (A) into
Nozzle Housing (B) allowing approximately 1/16" of the disposable nozzle
protruding as shown and tighten set-screw (C) to secure.
B
C
Important: Allowing no more than 1/16" to 1/8" of the plastic
disposable nozzle to protrude from the Tip shroud will assure the
adhesive will remain melted between actuations.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
Note: The Shroud is preset
at the factory. If adjustments
are needed follow the
instructions in step 12.
A
11