Scope - Analysis - Measures; Scope - Analysis - Zoom - Magneti Marelli FLEX TESTER Guía Rápida

Scope – Analysis - Measures
•
MEASURES. Flag shows/hides measures
screen. To enable the single measure please click on the area where the value will
be showed when activated. Measures are available for each channel and values
are calculated based on the traces depicted on the screen. Measure available are:
Maximum, Minimum, Period, Frequency, DC average, Duty cycle, Peak-Peak, Fall
time, Rise Time; High Pulse, Low Pulse
Scope – Analysis – Zoom
ZOOM Analysis. In standard mode the software shows the screen with 13bits of vertical
resolution to improve the refresh time and 1000 points in horizontal resolution (screen
limits).
Using zoom analysis permits the electrical signal to be shown with REAL 13bit vertical
resolution and always 1000 point in horizontal (depending on sampling rate selected).
•
Standard Zoom In. Select the specified button. Point where you want to zoom in
and click on the diagram.
•
Standard Zoom Out. Select the specific button. Click on the diagram and point
where you want to zoom out. The software realize a prefixed %zoom.
•
Customize Zoom. Select the specific button. Select the rectangular area that you
want zoom. Then click on the top left point, keep the left button pressed and move
on the right bottom of the area. Then release the mouse
•
Zoom off. Select the specific button to disable zoom analysis.
When Zoom analysis is active in the bottom right of the diagram you have a
preview of the complete screen. To pan the zoom area press and hold the left right
mouse button. Move the mouse then release the mouse.
The software realize a prefixed % zoom.
area on the
13