Autoadjust Patient Menu; Cpap Patient Menu - DeVilbiss Healthcare SleepCube AutoAdjust CPAP DV54 Serie Guía De Instrucciones

EN
Display Example
Auto-OFF
Enabled
Mask Fit Check
Enabled
Exit Menu
Press 
DV54 AutoAdjust Patient Menu Layout
The following chart shows by Mode each Display you will scroll through using the Next or Previous buttons on the keypad. Pressing the Down key
at the Enable Menu Display will allow you to enter this submenu - then use Next or Previous buttons to scroll through it; press the Up button to
return to main menu. Once the final Display is reached, pressing the Next button will return you to the first Display.
MENu - AutoAdjust Mode
P:10.0 Auto
Heat:5
Upper Limit
15.0 cmH20
Lower Limit
5.0 cmH20
Delay Time

10 minutes
Tubing Length

1.8 m (6 ft)
Enable Menu
Press 
LCD Contrast Adj
50%
Compliance Meter
123456.7 hours
Hourmeter
123456.7 hours
Firmware Version
V0.09 05/01/2007
Serial Number
HD123456
Adherence Score
83% (25/30)
SmartCode 1-Day
G201-0Y7-6GPH
SE-DV54
10
Description
This option controls the Auto-OFF feature, which automatically stops the flow of air after taking off the mask. The
device may require up to 30 seconds to turn OFF depending on the kind of mask used.
This option controls the mask fit check feature. The air flow to your mask is constantly measured and if the amount
of airflow exceeds 95 liters/minute for more than 10% of the time used, a notification will be created. This
notification will be displayed the next time you use the SleepCube.
Pressing the up key exits the Enable menu.
Auto-ON
Enabled
Auto-OFF
Enabled
Mask Fit Check
Enabled
Exit Menu
Press 
aDVancED mEnu controlS
MENu - CPAP Mode
P:10.0 CPAP
Heat:5
Set Pressure
10.0 cmH20
Delay Time

10 minutes
Delay Pressure
5.0 cmH20
Tubing Length

1.8 m (6 ft)
Enable Menu
Press 
LCD Contrast Adj
50%
Compliance Meter
123456.7 hours
Hourmeter
123456.7 hours
Firmware Version
V0.019 05/01/2007
Serial Number
HD123456
Adherence Score
83% (25/30)
SmartCode 1-Day
G201-0Y7-6GPH
Auto-ON
Enabled
Auto-OFF
Enabled
Mask Fit Check
Enabled
Exit Menu
Press 