Keypad; System Assembly Without Humidification; Keypad And Display; Operation - DeVilbiss Healthcare SleepCube AutoAdjust CPAP DV54 Serie Guía De Instrucciones

SyStEm aSSEmbly/opEration

sysTem assembly wiTHoUT HUmiDifiCaTion

NOTE
– If your system includes a humidifier, please refer to the instructions provided with the humidifier for assembly and operation.
1. Locate the air supply port and heater accessory connector on the bottom of the SleepCube device. Ensure that each opening has the appropriate
soft cover securely attached.
2. Place the SleepCube on a stable surface such as a nightstand or table. If you wish, you may also place the device on the floor at the bedside,
being careful to place the unit where it won't be kicked or stepped on. Ensure that the air inlet in the back of the device is not blocked by
anything such as curtains or bedding.
NOTE
– Never place the SleepCube system on a soft surface such as a bed or couch during operation.
CAuTION– The height of the SleepCube system must always be lower than the interface mask when using a humidifier to prevent water from getting into
the CPAP mask.
3. Insert the power cord into the back of the device. Make sure the power cord is fully inserted into the connector. Plug the other end of the power
cord into the AC wall outlet.
4. Attach the air supply tubing to the air supply interface in the back of the device.
5. Prepare the mask (supplied by your home care provider) by referring to the mask's instruction guide.
6. Connect the air supply tubing to the mask.
NOTE
– The air supply tubing supplied with the device is specially designed to prevent kinking and allow you to receive optional airflow. Use only the 22 mm diameter,
smooth-bore, kink-resistant tubing supplied with this device or an air supply tubing recommended by your home care provider.

KeyPaD anD DisPlay

Basic DeVilbiss SleepCube Controls
Name Symbol Function
ON/OFF The ON/OFF button starts and stops the flow of air from the device.

HEATER If your SleepCube has a heater/ humidifier attached, these buttons adjust the heater setting. Increase the setting for
more humidity and decrease the setting for less humidity.

DELAY The Delay button activates the comfort delay feature and only functions if this feature has been enabled. To understand
how to set the parameters of this feature, please refer to the Using the Comfort Delay Feature found on page 8.
NOTE–
The additional control buttons that you see on the SleepCube control panel provide advanced controls for specific settings. Please refer to the 'Advanced Menu
Controls' section on page 8 for more details.

oPeRaTion

Startup

To begin operation, verify that your SleepCube is connected to a 'live' power source. When plugged in, the LCD display
should appear as noted.
Put on your CPAP mask and press the ON/OFF button on the keypad to turn on airflow OR put on your CPAP mask and take a few breaths to
turn on airflow automatically. The pressure in your mask will rise to the set pressure in about 10 seconds.
NOTE
– If the device does not automatically start after taking 2-3 breaths, this feature may have been disabled. If Auto ON/OFF is disabled, you must manually press the
ON/OFF button to start and stop the device.
The keypad display shows the actual mask pressure while the device is in use. Because this is the actual pressure, the
device pressure reading may vary slightly as you breathe. Your display should appear as noted.
If your DeVilbiss SleepCube system includes a humidifier, its heater controls and status are displayed as noted in the
image.
NOTE–
If the display on your device is not similar to those listed above, refer to the chapter section titled "Patient Messages" on page 11.
EN
OFF
P:10.0 CPAP
P:10.0 CPAP
Heat:Off
SE-DV54
7