Using The Comfort Delay Feature; Shut Down; Advanced Menu Controls - DeVilbiss Healthcare SleepCube AutoAdjust CPAP DV54 Serie Guía De Instrucciones

EN

using The Comfort Delay Feature

Your SleepCube has a comfort delay feature to help make it easier for you to fall asleep. The airflow will start at a low pressure and then gradually
ramp-up to the prescribed setting over the last few minutes of the specified delay time.
NOTE–
When the delay comfort feature is activated, a message will flash on the display periodically, indicating the amount of time remaining in the delay.
You can adjust the amount of time spent in comfort delay by using the advanced device controls. The Delay Time can be
adjusted from 0 to 45 minutes in 5-minute increments. Refer to page 9 for details.
NOTE–
If you are unable to change the delay time, your provider has locked this setting. Refer to the keypad menu guide on page 9 for details.
When you use the comfort delay feature while your device is operating in CPAP mode, the airflow you receive at the beginning of your therapy is
temporarily lowered to a pressure selected by your physician when the device was setup.
Press the delay button to activate the comfort delay feature. The airflow pressure will drop to the prescribed comfort delay pressure.
In the final 10 minutes of the delay period, the pressure will gently rise to the pressure prescribed for your therapy. You may repeat the comfort
delay by pressing the delay button again if you have not fallen asleep during the first use.
When you use the comfort delay feature while your SleepCube is operating in AutoAdjust mode, the airflow you receive at the beginning of your
therapy is the lowest pressure prescribed by your physician when the device was setup.
You do not need to activate the comfort delay; it will turn on automatically. The airflow pressure will rise only to the low pressure setting and
remain there for the duration of the delay period. The AutoAdjust will not adjust the pressure setting during the comfort delay period, allowing you
to fall asleep without responding to early respiratory events.

Shut Down

Press the ON/OFF button to turn the device off. You may also simply remove your mask. After a few seconds the device will display the message
"Mask Off. Please check mask fit." If you do not put the mask on again the device will automatically turn off in about 20 seconds. Pressing any
button will remove the message from the display.
NOTE–
If the DeVilbiss SleepCube does not turn off automatically, the "Auot-OFF" feature may have been disabled. In this case you must manually turn the device off.

aDVanCeD menU ConTRols

With the device on, press the "Next" or "Previous" buttons on the keypad to scroll through the items on the display. Not all of the features in the
table below are available in all models; some are optional and some depend on what your physician and/or home care provider has selected. The
table shows the items you may see, and describes the feature associated with each item. Also, some features are only available in AutoAdjust Mode
or with the DeVilbiss SmartLink™ Therapy Management Module – these are noted in the 'Mode' column below. If you do not see some of these
options, your model or configuration does not support them.
Name Symbol
PREVIOUS ITEM
NEXT ITEM
SETTING CHANGE
Please note that the values displayed are examples only.
SE-DV54
8
Comfort Delay Feature In Standard CPAP Mode
Comfort Delay Feature in AutoAdjust Mode
Function
Pressing this button displays the previous menu option.

Pressing this button displays the next menu option.


These buttons allow you to adjust the setting that is shown on the display.

aDVancED mEnu controlS
Delay Running
10 Minutes Left