Technical Data; Before Initial Use - Charge Battery; Before Getting Started - Brill RazorCut LION 38 Instrucciones De Uso

Technical Data

Battery powered cylinder mower
Part number
Moisture protection
Cutting width
Cutting height
Sound power level
Sound pressure
Weight
Protection class
Battery
Type
Nominal voltage
Rating
Weight
Charger
Voltage
Charging time
Weight
Before initial use – charge
battery
For your safety
It is essential that you also follow the "Safety instruc-
tions for handling charger and battery" in chapter
"Important safety instructions".
The mains voltage must be in compliance with the
voltage specification (V~) on the type plate of the
charger.
Use only the supplied charger with corresponding
original Li-Ion battery. Operate charger only in dry
rooms.
For your information
The supplied battery is only partially charged.
Before initial use, fully charge battery. Charging
time during initial use is approx. 15 h During this
time, ensure that charging temperature stays
24
LION 38
65082
IPX 1
38 cm
20-45 mm stepless
settings
86 dB (A)
69 db
ca. 9,5 kg without battery
III
7S2P Li-Ion
25,2 V
2,6 Ah
1,2 kg
230 V / 180 mA
up to 15 Std.
0,2 kg
between 0 °C and +45 °C. This is the only way to
ensure a long battery life.
A significantly decreased runtime in spite of
charging indicates that the battery is dead and
must be replaced. Use only original Li-Ion batter-
ies, which you can purchase from manufacturer's
customer service.
Charger and battery can heat up during charging.
This is normal and not a sign of a technical defect.
The supplied Lithium-Ion battery can be charged
at any time, regardless of charge state. Premature
interruption of charging does not cause damage
to the battery. A protective circuit on the battery
prevents depth discharge of battery.
Charging
Remove battery from packaging
A
Figures
Connect charging plug 23 of charger 22 with charg-
A
ing socket 24 on battery 9. Now plug the charger 22
into the power socket. Charging begins when status
indicator 21 flashes green.
Charging is finished when status indicator 21 on battery
9 illuminates in green. After charging is finished, first
disconnect plug of charger from power socket, then
remove charging plug 23 from battery 9
Charging time for full charge is approx. 15 h.
Charging is interrupted when charger becomes too
hot; indicator on charger goes off. The integrated
battery protection circuit (PCB) switches off charg-
ing when battery temperatures exceed 45 °C.
Range of charging temperature is between 0 °C to
max. +45 °C.
After the charger has reached its operating tem-
perature again, charging is continued; the indica-
tor on charger illuminates in red.

Before getting started

The mower is disassembled in factory and must be
assembled according to operating instructions.
.