Publicidad
Idiomas disponibles
Idiomas disponibles
Fault
Abnormal sounds,
rattling on mower
Metallic impact sounds
Lawn turns yellow,
Unclean cut
Motor does not start
Motor does not start, status
indicator flashes red
Cutting equipment does not turn,
motor fails. PCB* has shut down
due to overload, status indicator
flashes red
Cutting equipment does not turn,
motor fails. Thermal protective cir-
cuit has shut down due to overload
Cutting equipment does not turn,
or only with difficulty
Possible cause
Loose screws on motor or mower
housing
Foreign object is blocking blade
roller
Cutting height too low
Cutting gap between blade roller
and lower blade is too large
Blunt cutting equipment
Missing battery
Faulty battery
Carrying strap is not resting against
battery
Battery not charged
Excessive temperature, thermo
protective circuit has triggered
Excessive temperature, PCB* has
shut down
Blockage caused by foreign object
or clippings
Blockage caused by foreign object
or clippings
Cutting height too low
Possible cause
Retighten screws
Switch off mower. Disconnect
circuit breaker and remove foreign
object
Increase cutting height
Readjusting cutting equipment
see chapter "Replacement of
cutting equipment"
Check battery / insert battery
Replace battery
Put carrying strap in place and
insert battery correctly
Charge battery
Wait ca. 3 - 10 minutes, then
restart mower
Allow mower to cool down, then
restart again
Switch off mower. Disconnect cir-
cuit breaker and remove foreign
object. Ensure that cutting equip-
ment turns freely. Remove clip-
pings from the area of the mower
housing. Mower can be restarted
immediately
Switch off mower. Disconnect
circuit breaker and remove foreign
object. Ensure that cutting equip-
ment turns freely. Remove clip-
pings from the area of the mower
housing. Wait ca. 3 - 10 minutes,
then restart mower.
Increase cutting height
29
Publicidad
Capítulos
