Descargar Imprimir esta página

Care And Maintenance - MESTO 3237 Serie Instrucciones De Uso

Ocultar thumbs Ver también para 3237 Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN

Care and maintenance

Observe the instructions in the section entitled "Safety".
After using the device 50 times or at least once a year:
• Unscrew the pump [2] from the tank. (Fig. 5)
• Dismantle the pump [2].
a) Unlock the piston rod with handle [9].
b) Pull the piston rod with handle [9] out of the cylinder tube up to the stop and turn it
counterclockwise. (Fig. 11)
c) Disconnect the piston rod with handle [9] and cylinder tube [2]. (Fig. 11)
• Grease the diaphragm [12]. (Fig. 12)
• Assemble the pump.
a) Push the piston rod with handle [9] into the cylinder tube. (Fig. 14)
b) Hold the cylinder tube [2] and strongly press in the guiding plug [13] with your thumb.
(Fig. 14)
c) Pull the piston rod with handle [9] up to the stop down and turn it clockwise. (Fig. 11)
► The guiding plug [13] snaps in.
• Lock the piston rod with handle [9] and screw the pump [2] into the tank [1].
• Grease the O-ring [11]. (Fig. 12)
Observe the legal requirements of your country for accident prevention and check
the device in regular intervals.
Unless otherwise specified, we recommend that an expert carries out an external
test every 2 years and an internal test every 5 years as well as a strength test every
10 years.
Faults
Use only original spare and accessory parts.
Fault
No pressure builds up in the
device
Liquid flows out of the pump
No tank pressure indication on
the piston pressure gauge.
Safety valves blow off too early.
Contact address for additional information → see title page.
Cause
The pump is not screwed
on tightly.
O-ring [11] on the pump is
faulty. (Fig. 13)
Diaphragm [12] is defecti-
ve. (Fig. 13)
Valve disc [14] dirty or
defective. (Fig. 15)
Piston pressure gauge [8]
is defective
15
ENGLISH
Remedy
Screw the pump on tightly.
Replace the O-ring.
Replace the diaphragm.
Clean or replace the valve
disc.
For safety reasons, it is not
possible to replace the sa-
fety valve/piston pressure
gauge.
Please contact your local
specialist or the manufac-
turer directly.

Publicidad

loading

Este manual también es adecuado para:

3237w primer h2o