Steelcase Thread Manual Del Usuario página 14

®
SINGLE DOOR MODULE INSTALLATION
5.
Make sure the foam seal is in place and not damaged (5a).
Install the two (2) M4 screws with a T20 torx bit to 7-10 in-lbs torque (5b).
NOTE: The single door module can be installed in any of the three (3)
available receptacles.
DOUBLE DOOR MODULE INSTALLATION
6.
Make sure the foam seals are in place and not damaged (6a).
Install the four (4) M4 screws with a T20 torx bit to 7-10 in-lbs torque (6b).
NOTE: The double door module must be installed directly across from
each other. The doors cannot be installed 90 degrees to each other.
5a
FOAM SEAL
6a
5b
6b
Page 14 of 75
24207101 Rev G