Power Track And Power Track Infeed Anchor - Steelcase Thread Manual Del Usuario

®
SYSTEM INSTALLATION (CONTINUED)
9.
POWER TRACK AND POWER TRACK INFEED ANCHOR POINTS
• (For floor infeed) Verify that two (2) screws are already installed in the cover.
• Install one (1) screw on each end of the power track or power track infeed. Install a
screw every 4 feet or less.
• NOTE: Extra screw holes are provided in case a rock exists in the concrete sub-floors
and the installer is unable to use a hole. Not all screw holes are required to be fastened.
• Ensure the power track or power track infeed is not strained prior to drilling holes or
driving screws for its attachment to the sub-floor.
• Ensure that all concrete and wood dust is vacuumed prior to anchoring power tracks or
power track infeeds to the floor and laying down carpet.
Risk of Fire or Electric Shock
• Only use holes provided in power track or power track infeed for fastening
to sub-floor. Do not drill or drive screws into the power track or power track
infeed in any fashion. Doing so may result in electric shock.
ANCHOR IN ONE (1) OF ANCHOR IN ONE (1) OF
FOUR (4) LOCATIONS FOUR (4) LOCATIONS
WARNING
ANCHOR EVERY 4 FEET OR
LESS WITH ONE (1) SCREW
USING THE PROVIDED HOLES
Page 17 of 75
24207101 Rev G