Connections; Connecting The Cables; Connecting The Charger; Preliminary Settings - Compex energy Manual Del Usuario

A On/Off button
B "i" button used to:
increase stimulation energies in several channels
simultaneously
C Sockets for the 4 stimulation cables
D Stimulation cables
Channel 1 = blue
Channel 3 = yellow
E +/- buttons for the 4 stimulation channels
F Socket for the charger
G Rechargeable battery compartment
H Belt clip socket

2. Connections

Connecting the cables

he stimulator cables plug into the 4
T
sockets on the front of the device.
our cables can be connected
F
simultaneously to the four channels of
the device. Both the sockets and the
cables are colour-coded to simplify use
and facilitate identification of the
different channels.
blue = channel 1
yellow = channel 3
The Energy stimulator bears the
m-
label , in other words it
READY
can use certain m technology
functions if a stimulation cable
m-4
fitted with the
connected. This cable, sold
separately, gives access to the
m-3
function. It is connected to
any one of the four stimulation
channel sockets located on the
front of the device and two
electrodes are "clipped" on to it in
the same way as for a
conventional cable.
Channel 2 = green
Channel 4 = red
green = channel 2
red = channel 4
system is

Connecting the charger

T he Compex has considerable operating
autonomy, as it uses rechargeable
batteries.
T o recharge them, use the charger
supplied with your device and connect it
to the front of the device, then plug the
charger in a socket.
R emove any stimulation cables connected
to the stimulator before recharging it.
W e strongly recommend you fully charge
the battery before using it for the first
time as this will improve its autonomy
and life span.

3. Preliminary settings

efore using the unit for the first time,
B
you should select the working language of
the device which is displayed on the
options screen. Follow the instructions
below. Afterwards, for the greatest
comfort, the Compex offers you a
number of setting options (operating
language selection, display contrast
setting, adjusting backlighting and volume
setting). To change any of these settings,
bring up the options screen by holding
the On/Off button on the left of the
stimulator for a few seconds.
159