General Information - Spanset DSL2 Manual Del Usuario

DSL2

General Information

The DSL2 is tested and certifi ed to
BS EN 360:2002, and has been tested
in accordance with the dynamic
performance requirements of EN355.
Certifi ed by Approved Body: SATRA,
Kettering UK. Identifi cation No:0321.
Production Control is audited by the BSI
– Identifi cation Number 0086.
It is essential that this product is sold
to the end user with the instructions in
the correct language of the country in
which the product is to be used. This
product is for use in a fall arrest system
that has had a thorough risk-assessment
including an analysis of the clearance
height necessary below the user to
ensure safety.
WARNING
The DSL2 is intended to be used as a
connecting element between an EN361
full body harness and an EN795 anchor
point (>12kN). A full body harness is the
only acceptable body holding device
to be used with a DSL2. If supplied as
part of a complete system, components
shall not be substituted. Use of this
equipment is inherently dangerous, and
prior to use you must
ensure that:
– This equipment must only be
used by persons who are in a fi t
medical condition to carry
out work at height in normal and
emergency situations.
– The DSL2 is intended as an
item of personal fall protection
equipment.
– Read and understand all
instructions and limitations
for use.
2
DSL2 0216-1.0
– Undertake specifi c training for
the correct use of the product.
– Become familiar with use of
the product prior to activities
at height.
– Understand and accept the risk
involved in use of the product.
– Perform all necessary pre-use
checks.
– Ensure that the designated
work area has adequate
supporting structural
attachments.
– ONLY use equipment relevant
to EC Directive 89/686/EEC
in conjunction with this piece
of equipment and check usage
instructions to ensure
compatibility.
Combinations of various items of
PPE are NOT inherently compatible
to provide a safe system of work.
The DSL2 is only designed to be used
as a connecting element between
an anchorage point and a full body
harness. Any combination of PPE other
than this may result in unsafe method
of work. If in doubt—contact SpanSet
UK for advice.
It is essential that prior to use of this
and other PPE a comprehensive rescue
plan is in effect and can be deployed
rapidly in the event of diffi culties. This
implies that users will also be trained in
the use of the rescue equipment.
FAILURE TO ADHERE TO THE
PRODUCT USER INSTRUCTIONS
MAY RESULT IN SERIOUS INJURY
OR DEATH.