Spanset DSL2 Manual Del Usuario página 5

The DSL2 has been designed for
working at height. The Lanyard has
a retractable element which helps
to minimise free fall distances. The
DSL2 comes in 2 confi gurations; Single
Lanyard for protecting workers using a
fi xed anchor point, or mobile anchorage
device and Twin Lanyard for protecting
workers who are climbing and traverse
between anchor points. The DSL2 is
designed to connect to the rear fall
arrest attachment via the supplied
EN362 connector, and locates on the
harness via the hook-and-loop retaining
straps on the shock absorbing pack.
PRE-USE CHECKS & WARNINGS
1. Ensure there is adequate free space
below the user to eliminate the risk
of collision with obstacles or the
ground during a fall. Refer to 'Annex
A' for detail of how to do this.
2. Ensure that the shock absorbing
pack shows no signs of
deployment.
3. Operate the retracting unit to
ensure that extension and
retraction function is operating
freely and does not allow any slack
to occur in the webbing.
4. Pull the webbing line out sharply
to check the locking mechanism
engages, and when release
retracts fully.
5. Ensure that the swivels at the user
connectors are free to rotate.
6. Operate the users connectors
to ensure that the gate mechanism
operates freely and locks
automatically.
7. All anchorages used must meet and
/ or exceed the requirements of
EN795 (>12kN)
8. Inspect the entire product for
signs of wear, deformation, damage
or corrosion.
9. Ensure that use of the device limits
the potential for collision from a
swing fall.
10. Be aware of the environment for
intended use. Hazards may include,
but are not limited to: excess heat,
caustic or corrosive substances,
high voltages, sharp edges.
Record serviceability and inspection
details on the Product History Card
which is supplied with all SpanSet
products.
WARNING! Do not make any
alterations or additions to this product
without SpanSet UK Ltd.'s written
permission. All repairs must be
carried out by a Trained person and in
accordance with SpanSet procedures.
IF THERE ARE ANY DOUBTS
ABOUT THE PERFORMANCE OF
THE DEVICES DURING PRE-USE
CHECKS THEN THE DEVICE MUST
BE REMOVED FROM SERVICE UNTIL
AUTHORISED BY THE SUPERVISOR
OR MANUFACTURER.
DSL2
Instructions For Use
Product Labelling
5
DSL2 0216-1.0