Installation Of Motor On Section Bar; Installation - V2 ATRIS Manual Del Usuario

5 - INSTALLATION OF MOTOR
ON SECTION BAR
1. Insert the shaft/pinion adapter B on the motor shaft.
m
WARNING: the adapter B has a direction of insertion.
Observe the direction as shown in the figure.
2. Position the section bar A on the motor: the shaft/pinion
adapter B must fit into the seat on the section bar.
Verify that the section bar fits snuggly against the motor.
3. Position the two omega brackets C on the section bar so that
they correspond with the holes on the base of the motor.
4. Fasten the two omega brackets using the 6 x 15 self-threading
screws provided D.
m
In case of lack of space, the motor can be mounted
rotated of 90°

6 - INSTALLATION

1. Disassemble the door's locking system.
2. Measure the door, and at exactly half its width mark the
reference points on the upper crossbeam and on the ceiling to
facilitate positioning of the guide section bar.
3. Fasten the bracket E to the upper crossbeam of the door using
plugs G suitable for the type of wall (ø minimum 8 mm).
4. Hook the section bar A to the bracket E using the
hexagonal-head F 6x80 screw with its self-blocking nut
5. Bend the 2 pierced bar H and M at the desired length
6. Fix the front pierced bar H to the fixing bracket I in the
section bar using the 8x20 screws L with their nuts
7. Fix the rear pierced bar M to the omega bracket N using the
8x20 screws L with their nuts
8. Following the references previously marked on the ceiling,
locate the fixing points for the bars H and M and using the
screws O suitable for the type of ceiling (minimum Ø 8 mm)
anchor the automation
E
A
G
F
O
O
H
I
L
D
C
O
M
O
N
L
- 28 -
A
B