V2 ATRIS Manual Del Usuario página 25

PARAMETER VALUE
Ft.tE
no
Si
Sic
no
StoP
EdGE
Co.tE
no
rESi
Foto
t.PrE
no
0.5" - 1'00
SPiA
FLSh
no
W.L.
LUCi
0.0" - 20'0
AUS
tiM
biSt
Mon
DESCRIPTION
Photocells test
The control unit checks the operation of the photocells before each work
cycle, for safety purposes. If the photocells pass the test, the gate begins
to open/close. Otherwise, the gate remains still and the control units
indicates that there is a malfunction.
Function deactivated
Function activated
Safety input
From this menu you can select the type of device to be connected to input
L5
Input disabled
STOP button (see paragraph 8.5)
Safety edge (see paragraph 8.5)
Safety edges test
The control unit checks the operation of the safety edges before each
work cycle, for safety purposes. If the photocells pass the test, the gate
begins to open/close. Otherwise, the gate remains still and the control
units indicates that there is a malfunction. This menu allows you to
activate the test based on the type of safety edge installed.
Function deactivated
Test enabled for conductive rubber safety edges
Test enabled for optical safety edges
Advance blinking time
NOTE: this feature is available only if parameter
Function deactivated
The flashing light is enabled before any door movement to warn the user
on the upcoming manoeuvre (the time can be set from 0.5" to 1'00)
Lights output
This menu allows you to configure the lights output
Flasher operation (fixed frequency 2Hz)
Output disabled
Indicator light operation: indicates the status of the door in real-time. The
type of blinking indicates the four possible conditions:
- DOOR STOPPED: Light off
- DOOR IN PAUSE: the light is on, fixed
- DOOR OPENING: the light blinks slowly (2 Hz)
- DOOR CLOSING: the light blinks quickly (4 Hz)
Courtesy light
This menu allows you to set the built-in courtesy light turn off delay at the
end of the cycle
The light turns on once the automation is enabled and turns off at the end
of the cycle, after the time set in this parameter
The light is controlled by means of channel 4 of the receiver
TIMER: the light turns on when channel 4 receives an enabling signal and
turns off after the time set in parameter
BISTABLE: the light turns on/off each time channel 4 receives an enabling
signal
MONOSTABLE: the light remains lit as long as channel 4 receives an
enabling signal;
SPiA = FLSh
LUCi
- 41 -
DEFAULT MEMO
no
no
no
no
FLSh
1'00
tiM