Chevrolet Performance 19303139 Instrucciones De Instalación página 5

Fuel Line Pressure Sensor
This sensor is necessary for operation of the Fuel Pump Power Module. The fuel line Pressure Sensor should be installed as far
away from the engine as practical in the fuel feed line. This will help dampen any fuel pressure spikes from the engine mounted
high pressure fuel pump. Do not use an impact drive to install the sensor. Torque to 15 NM +/- 5 NM. The sensor must be
mounted on an M10x1.0 port with an o'ring seal capable of sealing fuel. Pressure Sensor must be mounted as shown:
Fuel Pump Power Module
The Fuel Pump Power Module should be mounted as close to the fuel pump as practical and the wires powering the fuel pump
must remain twisted. If additional length is needed, maintain a twist of 27 turns per meter or 8 per foot to ensure adequate
protection from Electromagnetic Interference with the rest of the vehicle (i.e. radio and other control modules). The Fuel Pump
Power Module is fully sealed and can be mounted in any orientation but best practices should be maintained (i.e. away from heat
sources, maintain adequate clearance to moving parts, maintain adequate ground clearance, connector pointed in a downward
direction to prevent water intrusion etc). look up Corvette mounting for connector orientation)
Evaporative Emissions Valve
The evaporative emissions system can be used with the Chevrolet Performance Engine control kit, but is not required for proper
engine operation. The port must be either plugged or connected to a vapor canister.
EVAPORATIVE EMISSIONS PORT
LT1 Control System
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
5.0" TO 85.0"
ALLOWABLE MOUNTING ORIENTATION IN ANY
DIRECTION RELATIVE TO VERTICAL POSITION
19303139
REV 02JN16
PART NO.
DATE
Previous Revisions are Archived
02JN16 Revision - Blake Nye
5.0" TO 85.0"
SHEET
REVISION
5 39
OF
AUTH
N/A