Start-Up; Electric Wiring For Mod. Night One Day And Night One Day Auto; Open/Close Selector Switch For Mod. Night One Day And Night One Day Auto - FAAC Night ONE Day Manual De Instrucciones

11 START-UP

11.1 Electric wiring for mod. NIGHT ONE DAY and NIGHT ONE DAY AUTO

The NIGHT ONE DAY is commanded by a push-button
and operates in dead-man logic (As long as you press
the push-button, the motor will turn in the selected
direction).
The NIGHT ONE DAY AUTO is commanded by a switch
and automatically stops moving as soon as it meets
an obstacle or the opening/closing stop point.
1) Connect the yellow green cable to earth.
2) Connect the cables shown in the figure to the
230 V mains supply
According to the type of installation,
check if the push-button is correctly
wired. The shutters should open if you
press the Open key - if this does not
happen, change over the motor's two
phases (brown and black cables).

11.2 OPEN/CLOSE selector switch for mod. NIGHT ONE DAY and NIGHT ONE DAY AUTO

The figure shows the dimensions and electrical connections of the OPEN/CLOSE selector switch of the mod.
NIGHT ONE DAY a�d NIGHT ONE DAY AUTO
83
N L
0 Vac
0-0Hz
3x1,5mm 2
N = Blue or grey Blue or grey grey
L = brown

Fig. 34
4x0,75mm 2
3x1,5mm 2
Fig. 35