Electric Wiring For Mod. Night One Day Radio And Night One Day Radio Auto - FAAC Night ONE Day Manual De Instrucciones

11.3 Electric wiring for mod. NIGHT ONE DAY RADIO and NIGHT ONE DAY RADIO AUTO

The NIGHT ONE DAY RADIO models can be controlled
either by the remote-control or by a step-by-step logic
push-button.
The NIGHT ONE DAY RADIO AUTO can be commanded
either by the remote control or by a step-by-step
logic push-button and automatically stops moving as
soon as it meets an obstacle or the opening/closing
stop point.
1) Connect the yellow green cable to earth.
2) Connect the brown and blue (or grey) cables to
230V.
Do not connect the ReD or BlAck cable.
This is the ReSeT of the radio receiver.
See par. 11.4.3.
AUTOMATED SYSTEM CONTROLLED BY REMOTE-CONTROL ONLY: If you wish to use this type of configuration,
connect the motor's blue and brown wire to the power mains and the yellow-green wire to earth. Do not
connect the RED or BLACK wire.
AUTOMATED SYSTEM CONTROLLED BY BOTH REMOTE-CONTROL AND PUSH-BUTTON: If you wish to use this type
of configuration, connect the motor as shown in the lay-out in figure 36.
The push-button is provided with step-by-step logic - every pressure exerted on the key sends
a pulse to the motor (eXAMPle: FIRST PUlSe OPeNING - SecOND PUlSe STOP - THIRD PUlSe
clOSING-etc. ). After an opening or closing command, the motor stays active until end of
time-out (about 16-18 sec.).
Fig. 36
PUSH-BUTTON
N L
0 Vac
0-0Hz