Starting And Stopping The Engine; Operating Hints And Tips - Honda Power Equipment HRX C Serie Manual De Instrucciones

STARTING AND
STOPPING THE ENGINE
STARTING THE ENGINE
CAUTION:
• Do not start the engine with the blade clutch lever or the drive
clutch lever engaged.
[A] [B]
CHOKE FAST
For starting a cold For restarting
engine. a hot engine
and for mowing.
All models:
1. Open the fuel cock [1].
2. Place the throttle lever [2] in
"CHOKE" position [A].
NOTE: Place the throttle lever in "FAST"
position [B] when the engine is hot or the
ambient temperature is high.
3. Keep the blade brake lever
held [3] firmly against the
handle when starting the
engine.
All models:
4. Pull the starter [4] slowly until a
resistance is felt; then pull
sharply.
NOTE: Do not let the starter spring
back suddenly on its own; guide it
back slowly.
5. Once the engine has warmed
up (The engine runs evenly when the
accelerator lever is moved away from the "CHOKE"
position [A]), set the throttle lever to "FAST" position [B].
NOTE: To adjust the engine speed when the mower is running, the
throttle lever can be set anywhere between the "FAST" [B] and
"SLOW" [C] positions. However, the best results are obtained in
the "FAST" position [B].
The engine may stall if the lever is in the "SLOW"
position [C] when the blade clutch is engaged.
To facilitate starting, place the mower on a flat surface
where the grass is not long.
STOPPING THE ENGINE
1. Move the throttle control to the
"STOP" position [D].
1. Move the throttle control to the "SLOW" position [C].
2. Release the flywheel brake lever.
All models:
3. Turn the fuel cock "OFF" [5].
6 EN
SAFETY
[C] [D]
SLOW STOP
Selects engine Stops engine.
idling speed. (Rotostop models)
[1]
[5]
A1
FLOODED ENGINE
If the engine still refuses to start after several pulls on the starter,
the engine may be flooded.
To clear a flooded engine:
1. Place the throttle lever in "STOP" position [D] (Rotostop model).
2. Remove and dry the spark plug. When refitting the spark plug,
screw it up until it is finger tight and correctly seated. Then using
the plug spanner, tighten it an additional 1/8 to 1/4 turn so that
the washer is correctly compressed.
3. Next, place the throttle lever in "FAST" position [B] and repeat
the operations previously mentionned under the heading
"Starting the engine".

OPERATING HINTS AND TIPS

USING THE MOWER AT HIGH ALTITUDES
At high altitudes, the standard fuel/air mixture in the carburetor is
much too rich: this will reduce performance and increase fuel
consumption.
It is possible to improve the high altitude performance by fitting the
[2]
carburetor with a smaller diameter jet and by adjusting the pilot
screw. If you use your mower at an altitude of more than 1500
meters above sea level, we recommend that you have these
modifications made by your approved Honda dealer.
Even with the appropriate modifications made to the carburetor,
engine power will be reduced by about 3.5% for every 300 meters
of altitude. However, the altitude will have a much greater effect on
power if these modifications are not carried out.
CAUTION:
• Running the mower at an altitude less than that for which the
carburetor is adjusted may cause overheating and seriously
damage the engine, due to the gas/air mixture being far too
weak.
Take special care when mowing on uneven or irregular ground.
The mower may tip over, thus uncovering the blade; also, the
blade may throw out objects which were previously hidden.
Keep the four wheels firmly on the ground.
Control the direction of the mower using the handle and not by
exercing pressure on the blade casing with your foot.
CAUTION:
• When mowing around an obstacle, be careful that the blade does
not hit it. Never push the mower directly over an object.
• When mowing an uneven area, do not let yourself be pulled along
by the mower. Hold the handle firmly and control its advance.
[6]
[6] WRONG [7] RIGHT
C6
C7 C8
SAFETY
[7]