Complete The Installation - Kohler K-682 Guia De Instalacion

Power Supply
Optional External
Interface Cable
Molded Grommets
Internal Interface Cable
Drip Loop
Tab
Clip

11. Complete the Installation

CAUTION: Risk of product damage. The power supply is rated to operate in temperatures up to
104°F (40°C). Do not install the power supply under a whirlpool surround or any location where the
temperature may reach temperatures over 104°F (40°C).
CAUTION: Risk of product damage. Do not plug in the power supply until all interface cables are
connected.
IMPORTANT! Make drip loops in all cables and cords.
If the interface(s) is/are not installed at this time, install now according to the instructions packed
with the product.
Hold the power supply up to the install location and verify the cord will reach to the electrical
outlet.
Mark the hole locations.
Pre-drill the holes.
Secure the power supply with the screws.
If not already installed, install the interface(s) at this time according to the instructions packed with
the product.
Press the clips to release and open the door on the valve.
Slide the hinge side of the door in either direction until one side slips free.
Remove the door.
Connect the interface cable(s) to the valve.
Connect the power supply to the valve.
Kohler Co.
Door
15
Power Supply
Drip Loop
Screws
Drip Loop
1043183-2-B