Tecno-gaz ONYX B 7.0 Manual Tecnico página 95

ENGLISH
Spacer
(supplied) (3)
AUTOCLAVE POWER SUPPLY: connect the power cable (1) to the socket
device and the plug to the electrical system.
PLASTIC CAP: insert the spacer cap (3) (included in the supplied accessories kit) into the hole
located on the machine's rear carter.
"OVERFLOW" CONNECTION: connect the pipes to the overflow fittings at the back
the supplied 8 X 12 crystal pipe (6). The manufacturer recommends that this connection is always
made (water can be drained either into a tank or directly into the plant's waste water system).
PURA OSMOSIS CONNECTIONS: if an osmosis filling system is used, connect the system power
plug (2) to the electric socket behind the machine O, and the hose (not shown) to the tap
means of the supplied fitting (4) with the osmosis system, then open the tap to allow water to flow.
For continuous drainage of the used water, connect the male tubing connector to the tap T,
connect the crystal pipe (not shown) and open the tap to allow the water to flow out.
To be used for the
electric connection
(supplied) (1)
Pipe fitting for the
connection of the
PURA OSMOSIS
SYSTEM
(not supplied) (4)
Pipe fitting for the outlet
of the water tanks
(supplied) (5)
16
To be used for the
installation of the
osmosis system
(supplied with the
osmosis system) (2)
Cristal pipe 8x12
(supplied) (6)
Q at the back of the
S / U using
R by