MIL'S ANAESTIVAC 1 Manual De Funcionamento página 9

ANAESTIVAC 1 & 2 -
1. INTRODUCTION
1.1. Specification plates .............................................................................................................................................. 8
1.2. Specifications table .............................................................................................................................................. 8
2. DESCRIPTION
2.1. Side channel turbine ............................................................................................................................................ 8
2.2. The automatic vacuum relief valve ...................................................................................................................... 8
2.3. Lowest-level drip pot ........................................................................................................................................... 8
2.4. The isolating non-return valve ............................................................................................................................. 8
2.5. The control panel ................................................................................................................................................. 8
2.6. Automatic start .................................................................................................................................................. 10
2.7. Wall-mounted terminal unit .............................................................................................................................. 10
3. CHOICE OF ROOM
4. OUTLINE DIAGRAM
5. INSTALLATIONS
5.1. Dimensions ........................................................................................................................................................ 11
5.2. Installation ......................................................................................................................................................... 11
5.3. Power supply (see electrical circuit diagram attached) ..................................................................................... 11
5.4. Suction/exhaust connections ............................................................................................................................ 11
6. COMMISSIONING
6.1. Setting of the terminal unit flow ....................................................................................................................... 12
6.2. Testing the vacuum failure alarm ...................................................................................................................... 12
7. CLEANING AND MAINTENANCE
7.1. Monthly maintenance ....................................................................................................................................... 12
7.2. Yearly maintenance ........................................................................................................................................... 12
8. TRAINING
9. CLEANING
9.1. Units cleaning .................................................................................................................................................... 12
9.2. Network cleaning ............................................................................................................................................... 12
10. ELECTROMAGNETIC COMPATIBILITY
516962-12
Automatic pressure controlled / Automatic vacuum relief valve P.I.D
Symbols are used in these instructions to help you understand them and to indicate particular points which you
8
need to act upon or consider. Those symbols are:
Reading symbol: to refer to the operator manual / instructions manual.
8
Warning symbol: This symbol means that failure to observe this point could lead to injury and possibly
damage to the machine. It serves as a special reminder about regulations and/or the correct
implementation of certain precautions.
Danger symbol: This symbol represents the DIN 4844 symbol (hazard warning); it warns of a hazard
which could result in death or injury, along with damage to the machine. This symbol must be
10 observed by all personnel working on this machine. Regulations on safety in the workplace must be
observed.
11
11
Environmental protection symbol: This symbol serves as a reminder to sort waste during maintenance
operations, to store it in a safe place, and to dispose of it with due care for the environment.
Dustbin on wheels barred of a cross symbol: This symbol indicates that the equipment should not be
thrown with domestic waste and is subject to selective collection.
11
Biological hazard symbol: This pictogram informs of a risk or a danger, it is necessary to take care to
12 handle the biological products or waste being able to infect the living organisms by inhalation,
ingestion or cutaneous penetration.
12 Non-ionizing radiation hazard symbol: This pictogram informs of a risk or a danger related to non-
ionizing radiations
12
General remark:
12
If used in accordance with their intended purpose, units bearing the CE mark will satisfy the essential
requirements of directive 93/42/EEC relative to medical devices.
Those units, when installed in accordance with these instructions, comply with the provisions of currently
applicable European Directives and harmonised standards.
However, your attention is drawn to the fact that a unit with only one compressor or only one vacuum pump
cannot be used without an emergency backup device: gas backup or other fixed or mobile unit.
MEANING OF SYMBOLS USED IN THESE INSTRUCTIONS
To ensure personal safety and to avoid any damage to equipment, it is essential to follow the
instructions contained in this document and any other documentation provided with the
device, and particularly the instructions on "Safe Practice".
7