SentrySafe H060ES Manual Del Usuario página 9

Operating Safe with Personal Code
To unlock the door
1
2
NOTE: • If the code is incorrect, the display will show "E-CODE" and beep 3 times.
• "B" is a deletion key. Pressing it once will delete one character on the reader.
• In a low voltage condition, the display will show "LO-BAT" (in both a door open and
door closed state).
• A "b-LOC" message on the display during a closed door or open door indicates that the
door is not locked or will not lock. If this situation occurs, (1) unlock the unit; (2) hold
the door closed and attempt to re-lock it.
IMPORTANT
Three (3) repeated attempts to open the door using an invalid code will result in the safe being
automatically locked for 15 minutes. The safe will not respond to any code and the display will read
"HOLD" + "DIGIT" where the "DIGIT" is the amount of minutes you must wait until the safe will
respond to your code entry. After 15 minutes, the safe will return to normal operation.
Input the correct personalized four-digit code.
The display will show "OPEN", immediately followed by
"OPENED" indicating that the bolts are retracted into the door.
The spring loaded feature will enable the door to open
automatically.
9