Locking - Snap-On ATC 970S Manual De Instrucciones

quickLOK™ quickLOK™
A A
2
5.1-3
5.1-4
quickLOK™
3
5.1-5
Operations

5.1.2 Locking

1) quickLOK™ semi-automatic locking system
The semi-automatic locking and releasing system
(Figure 5.1-3) allows speeding up the locking.
• Grip the quickLOK
top only (arrow A).
• • Insert the taper (2a) fully onto the pivot (2b).
2
2a
KEEP A SAFE DISTANCE AWAY FROM THE AREA
UNDER THE RUBBER GUARD (2) ON THE quickLOK
• Insert locking tool (3) in the middle of the rim.
2b
2b
1.a) WI-FI-quickLOK™ Version
• press the locking switch (1) and keep the locking
system pressed fully home until it locks.
The wheel will be locked and ready for the tyre fi tting.
The warning light indicating the lock/release status on
the panel will turn on.
Always lubricate the contact surface between tyre and
rim, on both of them.
Note:
Note:
1.b) Standard quickLOK™ version
In the Quicklock version, wheel correct locking must be
verifi ed by visually checking the red reference position
(Figure 5.1-4) and, at the same time, by the selector
light turning on (3) (Figure 5.1-5).
3
TM tool with the LEFT HAND, at the
in case of switch malfunctioning, activate
the system by acting on selector 3
(Figure 5.1-5).
"If during the locking operation the button
(or switch) is kept pressed, the turntable
plate rotation does not stop with the
counter-rotation, but continues in the
same direction until the button (or switch)
is released. For safety reasons, rotation is
automatically ended by the machine after
approximately 15 seconds. You can make
another attempt after this time".
TM .
EN - 27