Storage; Disposing Of The Unit; Instructions For Disposal; Appendices - Snap-On ATC 970S Manual De Instrucciones

46 - EN
Maintenance

8.0 Storage

In case the machine is not to be used for a long period
of time (6 months or more) it is necessary to disconnect
all power sources, discharge the bead seater tank
(for models fi tted with the Tubeless beading System),
protect all parts that could be damaged, protect the air
hoses that may be damaged by the drying process.
When putting the machine back in operation, check
fi rst the condition of all previously protected parts, and
check for correct functioning of all devices before using
the machine again.
8.1

Disposing of the unit

To dispose of the equipment at the end of its life,
contact the reseller for a quote or for the regulations
on disposal which apply to the unit.
This symbol indicates that separate collection of waste
electrical and electronic equipment is mandatory for
scrapping.

8.2 Instructions for disposal

For electrical and electronic equipment European
directive 2002/95/EC, 2002/96/CE and 2003/108/
EC (RAEE)
At the time of disposal, at the end of the lifetime of this
equipment, you must:
1. Render the machine inoperative, remove the plug
and cut off the power supply cable close to where
it comes out of the machine.
2. DO NOT dispose of the equipment as urban waste
and recycle it, by taking the materials to suitable
recycling centres.
3. Contact the reseller for the closest authorised
recycling centres for the disposal or for the collection
of old equipment when purchasing new equipment.
4. Stick to the standards for correct waste management,
to prevent potential effects on the environment and
human health. Unauthorised disposal will result in
administrative sanctions for the offenders.

9.0 Appendices

This chapter contains additional information about
the unit.
If reference is made to the exact confi guration of the
unit, please note that the exact confi guration may be
different in your country. Consult the order confi rmation
for details.