Connect To Drain; Initial Start Up Instructions; Program Time Of Day; Set Day Of Week - Aquanex AQU36 Manual Del Propietário

sTeP 2 CONNECT TO DRAIN
Typical drain line runs to a floor drain, washing machine drain, sanitary sewer line with a p-trap, a
sink drain or a sump. CAUTION: Check with all local plumbing codes to insure proper instal-
lation in your area. An air-gap may be required. Be sure to install proper drain line size (see
specifications or Step 2B for sizing).
A. Slide a ½" I.D. tube onto hose barb located
on the back of the valve control body, (you
may want to secure tube with a hose clamp,
not provided). Connect the tubing to the drain
stub out provided with your pre-plumb loop.
Some pre-plumbs may provide an ABS drain-
pipe to run drain line to. CAUTION: Be sure
drain line discharges properly into a drain
to prevent flooding.
B. If the following conditions exist, it is recom
mended to increase the drain line tubing from
½" to ¾" I.D.
iniTial sTaRT-UP sTeP-bY-sTeP insTRUCTions
sTeP 1 PROGRAM TIME OF DAY
Time & Day Tin,e & Day
Capacity
Capacity
Hardness
Har dne ,,
sTeP 2 SET DAY OF WEEK
S U M O T U W E T H F R S A D A Y S
Time & Day
Tin,e & Day
Regen Time & Day
Regen Tin,e & Day
Salt
Salt
Capacity
Capacity
Har dne ss
Hardness
After steps 1-2, the controller will operate. Proceed to step 3 if further adjustments to your system's
programming is needed.
sTeP 3 SET REGEN TIME
Time & Day Tin,e & Day
Regen Time & Day
Regen Tin,e & Day
Salt
Salt
Capacity
Capacity
Hardness
Hardness
9 • 8/08 AQU36WS
1. Drain line run is over 20'.
2. Drain line vertical run is over 10 feet high
with incoming water supply pressure of 60
PSI. (You can increase or decrease height
of run 2 feet per 10 PSI. variations in either
direction, i.e. 12 feet vertical run with 70
PSI. or 8 feet vertical run with 50 PSI.).
A. Press the SET button. The display will flash 12:00
B. Use the UP and DOWN buttons to advance to the
correct time. Note "PM" is indicated, "AM" is not indi
cated.
C. Press the SET button to accept the time of day.
D. The control will advance to the DAY OF WEEK setting.
A. Press the SET button to make the cursor flash.
B. Use the UP and DOWN buttons to advance the flashing
cursor under the correct day of the week.
C. Press SET button again to accept the changes.
A. Default set at 2:00 AM for regeneration.
B. To change the regeneration time, press SET - causing
"2:00" to flash.
C. Use the UP and DOWN buttons to advance to desired
regeneration time.
D. Press SET to accept the time and advance to the next
parameter.