Specifications & Limitations; Installation Inspection - Aquanex AQU36 Manual Del Propietário

sPeCifiCaTions and liMiTaTions
Total Grain Capacity: AQU36
Maximum Ferrous Iron ("clearwater iron" only)**
Maximum flow rate to drain during
Water Pressure Drop at 5 GPM
Media Tank With Valve: AQU36
Salt/Potassium Storage Capacity
(salt recommended: 99.99% pure pellets
Approximate Shipping Weight (with no salt)
*Efficiency based at stated factory set salt
dosage only.
**Iron can be in several forms, pretreatment
will be necessary if certain types of iron are
encountered.
***Continuous means to a 110 outlet that has
continuous voltage not able to be turned off by
a light switch. GFI outlet recommended.

insTallaTion insPeCTion

is YoUR HoMe PRe-PlUMbed?
Your home is pre-plumbed for a water softener/conditioner if you have a loop in the garage or laun-
dry room. Typically, there will be 110 volt outlet within 6 feet of the loop and a ½" drain line stubbed
out of the wall. If your home is pre-plumbed, skip now to Step 1 of Installation Procedures.
CAUTION: Before starting up system, check water softener drain line to insure that it will drain
properly.
if YoUR HoMe is noT PRe-PlUMbed
If your home is not pre-plumbed for a water soft-
ener, then we recommend calling for profession-
al installation. If you are attempting to install the
system yourself, you must determine where to
locate the water softening/conditioning system.
The best location depends on several questions:
5 • 8/08 AQU36WS
Efficiency*
Maximum Water Hardness
Minimum pH
Regeneration Time
regeneration: AQU36
Water Pressure
Service Flow Rates: AQU36
Temperature
Bypass Valve Size
Drain Line Size
Electrical Requirements***
System Dimensions:
for maximum performance)
16,400@ Low (3.5 lbs.)
26,400 @ Standard (9 lbs.)
30,400 @ High (15 lbs.)
4,670 Grains/pound of salt @ 3.5 lbs. of salt
24-60 Grains Per Gallon
1-10 PPMS
7
Approximately 80 – 120 Minutes
2.1 GPM
20 Min. –120 Max. PSI 85 PSI day time pressure
10.7 GPM
0.6-1.0 PSIG
: 35° to 120° F •
air
¾" or 1"
½"
(under 20' run and lower than 10' vertical at 60 PSI)
¾"
(over 20' run or over 10' high, or over 7 GPM
backwash rates)
Continuous 110 Volt, 60 Cycles/2volt/24volt
10" dia. × 42" high
Foot Print 13" x 24" x 43.5"
150 lbs.
100-140 lbs.
These systems are efficiency rated and
conform to NSF/ANSI 44 for the specific
performance claims as verified and substan-
tiated by test data.
No reduction of specific contaminant claims
aQU36
: 35° to 100°F
water
GFI outlet
salida GFI
loop
caño curvo
drain source
suministro del desagüe