Descargar Imprimir esta página

Safety Rules - Kichler Sutter Place Select Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY RULES

1.
To reduce the risk of electric shock, ensure electricity has been
turned off at the circuit breaker or fuse box before beginning.
2.
All wiring must be in accordance with the National Electrical
Code and local electrical codes. Electrical installation should
be performed by a qualified licensed electrician.
3.
WARNING: To reduce the risk of fire, electric shock, or
personal injury, use mounting screws provided with the
outlet box. Most outlet boxes commonly used for the
support of light fixtures are not acceptable for fan support
and may need to be replaced. Due to the complexity of
the installation of this fan, a qualified licensed electrician is
strongly recommended.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
PERSONAL INJURY, MOUNT FAN TO OUTLET BOX
MARKED "ACCEPTABLE FOR FAN SUPPORT".
4.
The outlet box and support structure must be securely
mounted and capable of reliably supporting a minimum of
50 pounds. Use only CUL Listed outlet boxes marked "FOR
FAN SUPPORT".
5.
The fan must be mounted with a minimum of 7 feet
clearance from the trailing edge of the blades to the floor.
6.
Do ot operate reversing switch while fan blades are in
motion. Fan must be turned off and blades stopped before
reversing blade direction.
7.
Avoid placing objects in the path of the blades.
4 | KICHLER.COM
8.
To avoid personal injury or damage to the fan and other items, be
cautious when working around or cleaning the fan.
9.
Do not use water or detergents when cleaning the fan or fan
blades. A dry dust cloth or lightly dampened cloth will be suitable
for most cleaning.
10. After making the electrical connections, spliced conductors
should be turned upward and pushed carefully up into outlet box.
The wires should be spread apart with the ground wire and white
(common) wire to one side with the black (load) wire to the other
side of the outlet box.
11. Electrical diagrams are reference only. Light kits that are not
packed with the fan must be CUL Listed and marked suitable for
use with the model fan you are installing. Switches must be CUL
General Use Switches. Refer to the Instructions packaged with the
light kits and switches for proper assembly.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND
THE BLADE BRACKETS (ALSO REFERRED TO AS FLANGES)
DURING ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT
OBJECTS IN THE PATH OF THE BLADES.
SPECIAL NOTICE
This appliance is equipped with a "Wattage Limiting Device"
required by the United States Department of Energy. The device
has been installed at the factory and can not be removed.
Installing Lamps in excess of 75 total watts will disable the unit's
light fixture. If this should happen, you will need to reset the
lighting fixture by turning the power off to the ceiling fan and/
or light fixture, reinstalling lamps totaling less that 75 watts
and then turning the power back on.

Publicidad

loading