Installing The Light Fixture - Kichler Sutter Place Select Manual De Instrucciones

INSTALLING THE LIGHT FIXTURE

1. Remove the plastic plug from the center of the switch housing. Attach the light
fixture to the switch housing by feeding the light fixture wires (black & white)
through the hole in the center of the switch housing, then screw the light fixture
stem into the center hole. On the inside of the switch housing, place a lock washer
and a nut on the light fixture stem and tighten. (Fig.17)
2. Locate the white and blue wires inside the switch housing labeled FOR LIGHT.
Attach the wires from the light fixture to the wires inside the switch housing by
pushing the polarized connections together. (Fig.17)
- White wire to White wire
- Black wire to Blue wire
3. While holding the light fixture/switch housing assembly under your ceiling fan,
push the square wire connectors together. One from the fan and one from the
switch housing. (Fig.18)
NOTE: These connectors are color coded and will ONLY engage when the colored
strips are matched (aligned).
4. Carefully push all the wires into the switch housing on the light fixture/switch
housing assembly.
Attach the light fixture/switch housing assembly to the mounting plate with the
screws provided. Make sure each screw is tight. (Fig. 18)
Nut Wire Connectors
Lock Washer
Switch Housing
Plug
Light Fixture
Fig. 17
Mounting Plate
Wire Connector
Screws
Light Fixture/
Switch Housing
Assembly
Fig. 18
Sutter Place
™
13
Select |