Installing The Lamps & Glass Shade - Kichler Sutter Place Select Manual De Instrucciones

INSTALLING THE LAMPS AND GLASS SHADE
1. Install 3, 4 Watt, E-12 LED lamps (included).
2. Remove the decorative nut, glass cap and metal nut from the light fixture stem.
Slip the beaded pull chain into the outside hole in the glass shade then feed the
beaded pull chain from the light fixture stem through the eyelet in the shade. Now
place the glass shade over the light fixture stem. Secure the shade with a metal nut
(rubber side touching the shade). (Fig. 19)
3. Fit the decorative cap onto the light fixture stem and then slip the beaded pull
chain from switch housing through the hole on the side of the decorative glass
cap. Feed the beaded pull chain from the light fixture stem through the hold in the
decorative nut and thread the decorative nut on securely. DO NOT OVER TIGHTEN.
Light Fixture
4. Attach two pull chain fobs to each of the beaded pull chains. (Fig. 19)
Note: Make sure to leave enough space between the fan pull chain and the lamps so
Lamps
the chain doesn't rub against any of the lamps.
Glass Shade
Metal Nut
Beaded Pull Chain
Decorative Glass Cap
Decorative Nut
Fig. 19
14 | KICHLER.COM