Publicidad
Idiomas disponibles
Idiomas disponibles
1. Unlock the fill tube plug by lifting the plunger. Once the plunger is lifted, remove the entire plug assembly (1).
2. Determine the approximate amount of fluid needed to fill the transmission, based on the repair performed. Refer to
Approximate Fluid Capacities. To avoid an under-fill condition, slightly overfill the transmission, and then allow the extra fluid to
drain out through the oil level check plug during the transmission fluid level and condition check procedure.
Note: The DT-45096 flush and flow test tool is being utilized as a convenient method to pump the fluid into the bottom pan. A
suitable hand pump may also be used instead. When using the DT-45096 flush and flow test tool, monitor the display panel to
determine the amount of fluid being pumped from the tool supply tank into the transmission.
3. Using the DT-45096-40 transflow oil fill adapter (1) and the DT-45096 flush and flow test tool (2), or a suitable hand pump, add
transmission fluid through the fill tube plug opening. Refer to Transmission Fluid Cooler Flushing and Flow Test for complete
DT-45096 flush and flow test tool operating instructions. Use the FLOW position on the main function switch to pump the fluid.
Caution: Check the transmission fluid level immediately after adding fluid and before vehicle operation. Do not overfill the
transmission. An overfilled transmission may result in foaming or fluid to be expelled out the vent tube when the vehicle is
operated. Overfilling will result in possible damage to the transmission.
Check Plug Method
Caution: Use Dexron® HP transmission fluid only. Failure to use the proper fluid may result in transmission internal damage.
Note: When the oil level check plug is removed with the engine OFF, transmission fluid may drain from the hole.
Supermatic Transmission Controller Kit
TITLE
19371499
IR
AP1
PART NO.
4
30
SHEET
OF
Publicidad
