Iomega ditto Manual De Instrucciones página 11

Ocultar thumbs Ver también para ditto:

Idiomas disponibles

Important Compatibility information

Printing in Windows 95

With Windows 95, you may experience problems using the pass-through printing feature

of your Ditto drive. The cause of this problem is usually the printer's Status Monitor in the

printer manufacturer software. Until the printer manufacturers fix this problem, disabling

the printer's Status Monitor usually resolves the issue without affecting your printer's

performance.

At this time, the problem exists with parallel port printers connected to any type of parallel

port tape drive.

For some simple solutions, locate your printer in the chart below and follow the

instructions for the specified solution.

Printers

HP Laserjet 4L, 4+, 4V, 4SI, 4P, 5P, 5M, 6P, 6M

Brother HL630

Canon BJC 610, 620, and 4000 series

Lexmark

Okidata 600e

HP DeskJet 820C series

HP LaserJet 5L

If your printer is not listed, try solution #1; your printer may have been added to Windows

95's generic printer drivers after this guide was printed. If solution #1 does not correct

your printing problem, contact your printer manufacturer.

Solution #1

Use Windows 95 Generic Printer Drivers

1 Click the Start button on the taskbar.

2 Select Settings then Printers. (Note the name of your current

printer:__________________________________________)

3 Double-click on the Add Printer icon.

4 Click Next.

5 Choose Local Printer and click Next.

6 Select your printer manufacturer and type of printer and click Next. (Do not

choose Have Disk.)

7 A screen may display stating you already have this driver installed. If this screen

displays, choose Replace Existing Driver and click Next.

8 Choose the port for the printer (usually this is LPT1) and click Next.

Solutions