Harbor Breeze 00724 Manual De Usuario página 5

ASSEMBLY INSTRUCTIONS
7. Align the notches on the fan motor (B) canopy
with raised areas inside the trim ring (C). Pop
the trim ring (C) into the canopy.
8. Remove and discard preassembled rubber
shipping stabilizer tabs (I) from fan motor (B).
Insert blade (D) into slot on fan motor (B).
Secure blade (D) with three blade screws (BB).
Repeat for remaining blades (D) and blade
screws (BB).
Hardware Used
Blade Screw x 9
BB
9. Loosen two screws from switch housing plate
(H). Remove and save remaining screw.
7
Notch
C
Raised
area
8
B
Slot
I
BB
9
H
Screw
8
ASSEMBLY INSTRUCTIONS
10. Connect the 9-pin plug exiting the bottom of
the fan motor (B) to the 9-pin plug from the
light plate (E). Be sure plugs snap together
completely. Attach light plate (E) to switch
housing plate (H). Align keyholes, then twist to
lock. Replace previously removed screw (Step
9, page 8) and securely tighten all screws.
Canopy
B
11. Loosen two preassembled screws from
light plate (E). Remove and save remaining
preassembled screw from light plate (E).
D
12. Connect the WHITE wire from the light plate
(E) to the WHITE wire from the light fixture (F).
Connect the BLUE wire from the light plate (E)
to the BLUE wire from the light fixture (F). Align
the keyhole slots on the light fixture and the
light plate (E), and twist to lock. Replace the
previously removed screw (Step 11, page 9)
and securely tighten all of the screws.
10
B
Male
plug
Female
plug
E
Screw
Keyslot hole
11
E
Screw
12
E
Blue
F
Screw
9
H
White