Operating Instructions - Harbor Breeze 00724 Manual De Usuario

ASSEMBLY INSTRUCTIONS
13. Align the three flat areas on the top flange of the
glass (G) with the three raised dimples in the
light fixture (F). Insert the glass (G) into the light
fixture (F), then turn the glass (G) clockwise
until it stops.
CAUTION: Avoid touching the LED with your bare
hands. Be sure the power is off and the glass and
LED are cool before cleaning the fixture.
14. OPTIONAL: If desired, the wall bracket in
remote pack (J) can be installed to house
the remote control. Remove the small plate
preassembled on the wall bracket and use the
screws in remote pack (J) to secure the wall
bracket at desired mounting location. Replace
the small plate, then rest the remote control
from remote pack (J) into wall bracket.

OPERATING INSTRUCTIONS

Note: The receiver for the remote control is already wired and built into the fan canopy from
the factory; receiver assembly is not needed.
Note: If you have more than one remote controlled fan installed in the same location, you
may want to change the frequency of the remote control to avoid any possible interference
between remote controls. To change the frequency of the remote control, change the dip
switch settings as described in Step 1, page 11.
13
Raised
dimples
F
Flat area
G
14
Small plate
Screws
Wall bracket
10
1. Install Battery / Learning Process:
Remove the battery cover from the back of the remote
found in the remote pack (J). Insert the battery from
the remote pack (J) into the remote; ensuring polarity
of battery matches the polarity indicated in the battery
compartment -- positive (+) to positive (+) and negative
(-) to negative (-). Replace the battery cover.
If you need to change the dip switches in the remote
control due to a potential interference issue, slide the
dip switches to your choice of either up or down -- the
factory setting is up. Within 30 seconds of turning the
fan's power on, press and hold the "Learn" button on
the remote control for 1 second. Once the receiver has
detected the set frequency, the downlight of the fan will
blink twice. Replace the battery cover. To confirm the
remote control and receiver have paired successfully
press any of the fan speed control buttons on the remote
control.
2. Fan Speed Control / Dimmer:
0 Low speed
0 0 Medium speed
0 0 0 High speed
O Turns fan off
Turns light on or off
NOTE: For the dimmer function, press and hold the
light button. Light will dim. Release the light button
when light is at desired level.
NOTE: This remote control has a memory function.
The receiver stores the fan speed and light setting
when the fan is turned off. When the fan is turned on
again, it will start with the most recent settings.
3. Season Slide Switch:
When the season changes, you may want to change the
direction the fan blades spin. To switch between clockwise
and counterclockwise rotation, flip the season slide switch.
WARNING: Wait for fan to stop before reversing switch.
• In warmer weather, counterclockwise rotation creates a
downward airflow, which cools the air. Push the switch
LEFT and see a Sun icon.
• In cooler weather, clockwise rotation creates an upward
airflow, which moves hot air from the ceiling into the
room. Push the switch RIGHT and see a Snowflake icon.
1
Learn key
Dip switch
2
3
11