Tabla de contenido
Publicidad
Front Wall Assembly
Parts Needed:
2
Front Wall Joiner Panels
1
Right Door Jamb Groove Panel
1
Left Door Jamb Groove Panel
2
Corner Posts
1
Door Lintel
1
Header Assembly
4
Slope Wall Caps
4
Fascia Gables
2
Ridge Beam Sections
2
Ridge Beam Steel Support Beams
2
Ridge Beam Steel Support Beams
1
Ridge Beam Extension Cap Cover
8
Ridge Beam Steel Insert Beam Bolt Set
Screws #10 x 3/4" (1.90cm)
(Right and left are determined when facing
the front of building.)
1
8
Lay out all the required parts on the
1
8
ground around your foundation in their
proper sequence. Note that the front wall
panels are angled at the top edge and
vary in length. The door hinges must
face the outside of building on the DJ1 panel and DJ2
panel respectively.
2
0
2
0
Install a corner
post. Repeat to
install JT2 and
DJ2 in left front
corner.
10
AL7
2
1
2
1
Add door lintel (AL7) across top of front walls.
The door lintel's grooved surface should face up
and screw holes should face inside of building.
THE BALMORAL
1
9
1
9
Insert JT2 and DJ1
in front base chan-
nel at the right
front corner.
Publicidad
Tabla de contenido
