Part Identification; Tools Required; Materials Needed - Royal Outdoor Products PREMIER Serie El Manual Del Propietario

THE BALMORAL

Part Identification

Joiner panel
Slope wall cap
Base channel Door lintel
Vent Slide lock
Full-Scale Hardware

Tools Required

• Power drill with Phillips ®
(#2) or a #2 square bit
• Ladder
• Carpenter's square
• Level
• Rubber mallet
• Hammer
• Safety glasses
• Gloves
• Measuring Tape - Minimum
16' feet (5m)
• Wrench - 7/16" size
Phillips is a registered trademark of PhillipsScrew Co.
Fascia gable
Roof fascia cap
Door handle
Screw
#10 x 3/4" (1.90cm)

Materials Needed

• Foundation screws
• Silicone Caulking
• Paint for Doors - Exterior
grade enamel
• Door Key Lock Set
Groove panel
Ridge beam
extension cap cover
Roof fascia cap cover
Door Sweep
Door Handle Screw
#9 x 1" (2.54cm)
Nut
3
Corner post
Ridge beam Ridge support beam
Ridge beam end cap
2 Prong hinge plates
Hinge Screw
#9 x 1" (2.54cm)
Washer Bolt
Door pin
Astrigal