Tabla de contenido
Publicidad
THE BALMORAL
40
Before attempting to align
40
doors, while inside the
building, insert a screw in
the first hole of the base
channels at the door jambs.
Double-check 1/4" (.63cm) gap between
doors and front wall. If doors are uneven,
refer to step 41.
Note: The door hinges have a special
mechanism that keeps the door locked into
the hinge even if pins are removed. Do not
remove the hinges.
Door Jamb
Door
Install Screw
Base Channel
41
41
Door Alignment Tips
1. Before you install screws in the slope wall caps (roof/wall line),
you must align the doors. DO NOT install screws unless the
doors are lined up properly.
2. Ensure the doors are not upside down. The door sweep groove
must be at the bottom.
3. If you have installed your doors and you are experiencing
problems, as in Figure A, use the following instructions to cor-
rect:
To obtain an even vertical gap between the doors, i.e. the
doors are touching at the top or the bottom, gently push the
building back and forth, not side to side. To obtain an even
horizontal gap between the doors and the door lintel, i.e. the
top of one door is higher than the other, gently push the shed
side to side. You will notice that the doors shift as you push the
building.
4. If you have installed your doors and you are experiencing
problems as in Figure B, use the following instructions to cor-
rect:
In Figure B, the right door does not line up properly with the
left door because the bottom of the right door appears bent
inward. To correct this, gently push on the building at the top
of the front right corner (at the point shown in Figure B) until
the right door is aligned properly. If the left door appears bent
inward, correct the alignment by pushing on the top left corner
of the building.
5. Complete your assembly by installing a few screws at a time.
For example, install two or three screws and check your doors.
Repeat this procedure until all the screws are installed.
6. If you are still experiencing problems, call the 1-800 consumer
service line for assistance.
1/4" (0.63 cm)
Figure A
Door Juts Outward
Door Juts Inward
Figure B
15
1/4" (0.63 cm)
1/4" (0.63 cm)
1/4" (0.63 cm)
Publicidad
Tabla de contenido
