Care And Cleaning; Flushing Your Whirlpool System - Kohler K-1418 Guia Del Usuario

Programming Your Remote Control
NOTE: Programming of the remote control is normally not required. If more than one device in your home, or in
the near vicinity of your home, uses a remote control, it may be necessary to program this remote control to the
user keypad. If you replace your remote control, or replace the pump control, it may be necessary to program the
remote control.
- Turn power on to the whirlpool.
- Turn off all modes of operation. Wait approximately one minute until the keypad darkens (sleep mode).
- On the user keypad, press the up arrow, down arrow and the "OK" button simultaneously. The bottom LED, on
the keypad's indicator bar, will begin flashing.
- While the LED is flashing, press the "OK" button on the keypad. A light sequence will illuminate up and down
the indicator bar.
- While the indicator bar light sequence is active, press any button on the remote control. The program will
download and the user keypad will darken. The user keypad will now respond only to this remote control.
Care and Cleaning Instructions
Cleaning Your Acrylic Bath Whirlpool
- Do not use abrasive cleansers or solvents on acrylic surfaces.
- Wipe out your acrylic whirlpool with a soft cloth after each use.
- Avoid detergents, disinfectants, or cleaning products in aerosol cans.
- If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409r All Purpose
Cleaner, Gel Glossr (Bath and Shower only), Scrub Freer Mildew Stain Remover, Mr. Clean Lemon Fresh, Cinchr,
Glass Plusr, or Fantastikr All Purpose.
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub
scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not
wax areas where you walk or stand.
Cleaning Your User Keypad and Remote Control
- Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty, use a
non-abrasive soap and warm water to clean.

Flushing Your Whirlpool System

Flush your whirlpool system twice a month or more, depending upon usage. Use the following sequence:
- Turn the jet trim rings fully clockwise to remove air induction.
- Fill the whirlpool with warm water to a level at least 2" (5cm) above the highest jets, or leave water in the
whirlpool after using.
- Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of household bleach
(5% - 6% sodium hypochlorite) to the water.
- Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
- If desired, rinse the bath surfaces with water.
- Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.
Kohler Co.
9
A
1023249-5-