Descargar Imprimir esta página

Waterpik WP-450 Manual De Instrucciones página 14

Ocultar thumbs Ver también para WP-450:

Publicidad

Idiomas disponibles

Idiomas disponibles

26
CLEANING AND TROUBLESHOOTING YOUR WATERPIK
TIP USAGE
Pik Pocket™ Tip
The Pik Pocket
tip is specifically designed to
deliver water or anti-bacterial solutions deep
into periodontal pockets.
To use the Pik Pocket
tip, set the unit to the
lowest pressure setting. Place the soft tip
against a tooth at a 45-degree angle and gently
place the tip under the gumline, into the pocket.
Turn the unit on and continue tracing along the gumline.
Tongue Cleaner Tip
To use the tongue cleaner tip, set to lowest pressure setting,
place tip in the center/middle of your tongue about half way
back and start the Water Flosser. Pull forward with light
pressure. Increase pressure as you prefer.
Orthodontic Tip
To use the orthodontic tip, gently glide tip
along gumline, pausing briefly to lightly brush
area between teeth and all around orthodontic
bracket, before proceeding to the next tooth.
Toothbrush Tip
Place the toothbrush tip in mouth with the
brush head on the tooth at the gumline.
20021794-FAA_WP450B_IM_revs_rd6.indd 26-27
®
WATER FLOSSER
The toothbrush tip can be used with or without toothpaste. Turn the Water
Flosser on so the water flows through the tip. Using a light pressure
(bristles should not bend) massage the brush back and forth with very short
strokes-much like you would with a manual toothbrush.
Plaque Seeker
®
Tip
To use the Plaque Seeker
®
tip, place the
tip close to the teeth so that the bristles
are gently touching the teeth. Gently glide
tip along gumline, pausing briefly between
teeth to gently brush and allow the water to flow between the teeth.
Using Mouthwash and Other Solutions
Your Waterpik
Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to
prevent clogging by partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.
Cleaning
Never immerse unit in water. Before cleaning, unplug from the electrical
outlet. Clean the product when necessary by using a soft cloth and mild
non-abrasive cleanser to wipe exterior.
The water reservoir is removable for easy cleaning and is top rack
dishwasher safe. It is recommended that the reservoir is removed and
cleaned weekly.
Removing Hard Water Deposits
Hard water deposits may build up in your unit, depending on the mineral
content of you water. If left unattended, it can hinder performance.
Cleaning internal parts: add 2 tablespoons of white vinegar to a full
reservoir of warm water. Point the handle and tip into sink. Turn unit ON
and run until reservoir is empty. Rinse by repeating with a full reservoir of
clean warm water.
This process should be done every 1 to 3 months to ensure optimal
performance.
Battery Care and Disposal
The unit will not charge if the switch is in the ON (I) position. If you use
your Water Flosser once a day or less, it is recommended you charge it
overnight, once a week. If you use it twice a day or more, charge the unit
more frequently. Do not run the batteries down completely as this may
shorten the lifespan of the batteries and will require charging the unit for
24 hours to obtain a full charge.
If the Water Flosser is to be stored for an extended period of time (six
months or more), be sure to fully charge it prior to storage. The unit
contains a Nickel Metal Hydride battery. At the end of the battery life,
please recycle the unit at your nearest recycle center per local or state
requirements. The battery is not replaceable.
Service Maintenance
Waterpik
Water Flossers have no consumer-serviceable electrical items
®
and do not require routine service maintenance. For all your service needs
LIMITED ONE-YEAR WARRANTY
go to www.waterpik.com/intl to find your local distributor. Please do not ship
product to Waterpik International, Inc. offices, this will delay service.
Some replacement parts and accessories for the Water Flosser are also available
from your local distributor which can be found at www.waterpik.com/intl.
Refer to the serial and model numbers in all correspondence. These numbers
are located on the back of the handle and bottom of the reservoir respectively.
Still have questions? Go to www.waterpik.com/intl to find your local distributor.
Water Pik, Inc. warrants to the original consumer of this new product
that it is free from defects in materials and workmanship for 1 year from
the date of purchase. Consumer will be required to submit the original
purchase receipt as proof of purchase date and if requested, the entire
product, to support a warranty claim. Water Pik, Inc. will replace at its
discretion any part of the product, which in its opinion is defective,
provided the product has not been abused, misused, altered or damaged
after purchase, was used according to instructions, and was used only
with accessories or consumable parts approved by Water Pik, Inc.
Installation is the responsibility of the consumer and is not covered by the
warranty. This limited warranty excludes accessories or consumable parts
such as tips, etc. Use with improper voltage will damage product
and VOID warranty.
This warranty gives you specific legal rights. You may also have other
rights that vary, depending on the law in your place of residence.
4/26/16 2:28 PM
27

Publicidad

loading

Este manual también es adecuado para:

Wp-462