Care And Maintenance; Troubleshooting - Harbor Breeze E-TM52BNK5CS Manual De Instrucciones

CARE AND MAINTENANCE

At least twice each year, lower canopy (B) to check mounting bracket (A), and then tighten all screws
on fan. Clean fan with only a soft brush or lint-free cloth to avoid scratching the finish. Clean blades
(D) with a lint-free cloth. You may occasionally apply a light coat of furniture polish to wood blades for
added protection.
IMPORTANT: Shut off main power supply before beginning any maintenance. Do not use water or a
damp cloth to clean the ceiling fan.
Bulb Replacement: Use 40-watt max. candelabra-base bulbs or 11-watt CFL bulbs.

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not
1. Reverse switch not engaged.
move.
2. Power is off or fuse is blown.
3. Faulty wire connection.
Noisy operation.
Excessive
wobbling.
Fan operates but 1. Bulb(s) not installed correctly.
lights fails. 2. Wires in outlet box not wired
3. Wall switch to fan is off.
POSSIBLE CAUSE
1. Blades are loose.
2. Cracked blade.
3. Full range dimmer switch.
4. Fan is new.
1. Blades are loose.
2. Blade arms incorrectly attached.
3. Fan not securely mounted.
4. Fan too close to vaulted ceiling.
5. Set screw(s) on motor housing yoke
is (are) not tightened properly.
6. Set screw on hanging ball is not
tightened properly.
properly.
CORRECTIVE ACTION
1. Push switch firmly either left or
right.
2. Turn power on or check fuse.
3. Turn power off. Loosen canopy
and check all connections.
1. Tighten all blade screws.
2. Replace blade.
3. Replace with an approved speed
control device.
4. Allow fan a "break in" period of a
few days, especially when running
the fan at Medium and High
speeds.
1. Tighten all blade screws.
2. Re-install blade arms.
3. Turn power off. Carefully loosen
canopy and verify that mounting
bracket is secure.
4. Use a longer downrod or move fan
to another location.
5. Tighten yoke set screw(s)
securely.
6. Carefully loosen and lower canopy
and verify that set screw on
hanging ball is tightened securely.
1. Re-install bulb(s).
2. Check wires in outlet box and, if
necessary, re-wire according to
instructions on pages 10 and 11.
3. Make sure that wall switch to fan
is on.
Lowes.com/harborbreeze
16