Harbor Breeze E-TM52BNK5CS Manual De Instrucciones página 8

FAN MOUNTING
2. Insert downrod (O) through canopy (B), canopy
cover (R) and yoke cover (G). [NOTE: Canopy
cover (R) must be turned with the shiny side
toward the motor housing (J).] Thread wires
from motor housing (J) through downrod (O).
3.
4. Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested you do so in the
following manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the ball on the
downrod and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included).
NOTE: If you do not cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead.
2
B
R
3
Q
J
4
Lowes.com/harborbreeze
8
O
G
G
O
Set
Screw
P
Ball
B
O