Final Installation - Harbor Breeze E-TM52BNK5CS Manual De Instrucciones

FINAL INSTALLATION

1.
Locate two canopy mounting screws (K) on
underside of mounting bracket (A) and remove
canopy mounting screw (K) closest to the open end
of the mounting bracket (A). Partially loosen the
other canopy mounting screw (K). Lift canopy (B) to
mounting bracket (A). Place rounded part of slotted
hole in canopy (B) over loosened canopy mounting
screw (K) in mounting bracket (A) and push up.
Twist canopy (B) to lock. Re-insert canopy mounting
screw (K) that was removed, and then tighten both
canopy mounting screws (K). Slide canopy cover
(R) up to canopy (B), aligning rounded part of
slotted holes in canopy cover (R) with screwheads
in bottom of canopy (B). Turn canopy cover (R) to
the right (clockwise) until it stops.
2.
Partially insert three blade screws (AA) along with
three fiber blade washers (BB) to attach one blade
arm (C) to a blade (D). Then, tighten each blade
screw (AA) starting with the one in the middle.
Repeat with remaining blades (D).
Hardware Used
Blade Screw
AA
Fiber Blade Washer
BB
3. Locate motor screws (E) and lock washers (F)
removed in Step 5 on page 7.
Insert two motor screws (E) along with lock washers
(F) through one blade arm (C) to attach blade arm (C)
to motor. Tighten motor screws (E) securely. Repeat
with remaining blade arms (C), making sure to
completely secure each blade arm (C) before
proceeding with the next.
1
K
2
AA
BB
x15
x15
3
Lowes.com/harborbreeze
12
B
R
D
C
J
D
F
C
E