Servicing; General; Routine Checks; Adjustments - Vinten Osprey light Manual Del Usuario

General

The Osprey Light pedestal is robustly made to high engineering standards and little attention is required to
maintain serviceability save regular cleaning. Attention to the following points will ensure a long and useful
service life with minimum need for repair.
Cleaning
During normal studio use, the only cleaning required should be a regular wipe over with a lint-free cloth.
Dirt accumulated during storage or periods of disuse may be removed with a semi-stiff brush. Particular
attention should be paid to the track strips on the moving column.
NOTE: Do NOT use oil or grease on any exposed part of the column. This is unnecessary and
traps dirt which acts as an abrasive.
Use out-of-doors will require special attention, especially in adverse conditions. Salt spray must be washed
off with fresh water at the earliest opportunity. Do not allow water to enter the column. Sand and dirt acts
as an abrasive and should be removed with a semi-stiff brush or vacuum cleaner.
NOTE: Use only detergent-based cleaners. Do NOT use solvent- or oil-based cleaners,
abrasives or wire brushes to remove accumulations of dirt, as these damage the
protective surfaces.

Routine checks

Check the following during normal use:
Check for ageing and cracking of the rubber strut securing straps and renew if necessary.
Check the effectiveness of the drag control and skid clamp. Adjust if necessary.
Check for radial or side play in the moving column. Adjust if necessary.
Check the condition of the safety catch. Arrange a product service if necessary.

Adjustments

Adjustments that may become necessary after considerable use are as follows:
Taking up wear in the drag control knob.
Taking up wear in the skid clamp.
Elimination of radial and side play in the moving column.
Steering adjustments.
Drag control knob adjustment
(Fig 6)
When turned fully clockwise, the 'V' notch on the drag control knob should be within the limits shown. To
adjust the drag control knob:
Turn the drag control knob fully clockwise.
24

Servicing