Vinten Osprey light Manual Del Usuario página 26

Remove the hole plug (6.1). Remove the screw (6.2) and washer (6.3) securing knob (6) to the
spindle (6.4).
Remove the knob, then replace on spindle (6.4) so that the 'V' notch on the knob is within the limits
shown.
Degrease screw (6.2), coat with Loctite 222E and secure knob with washer (6.3) and screw (6.2).
Replace hole plug (6.1).
Skid clamp adjustment
(Fig 1)
To adjust the skid clamp (16):
The skid clamp is applied or released by turning the handle clockwise or counter-clockwise. The
handle has a pull-off/push-on ratchet adjustment. To take up wear, pull the handle away from the
spindle, rotate counter-clockwise and release.
Repeat the above procedure, as necessary, until the clamp locks when applied but allows free
movement when released.
Elimination of radial and side play in the moving column
If excessive radial or side play is apparent in the moving column, refer to the appropriate section in the
Maintenance Manual. This adjustment should be carried out by a competent person.
Steering adjustments
Inaccuracies in steering may be due to slackness in the steering belt or steering chains, or inaccurate track-
ing. Checking and adjustment should be carried out by a competent person as described in the appropriate
section of the Maintenance Manual.
English
25