Before Initial Use - Beem MD-258BT Manual De Instrucciones

21
WARNING – Danger of Fire
• Do not use the device in rooms containing easily ignitable dust or poisonous and explosive
fumes.
• Do not connect the device along with other consumers (with a high wattage) to a multiple
socket in order to prevent overloading and a possible short circuit (fi re).
• Do not operate the device in the vicinity of combustible material. Do not place any combus-
tible materials (e.g. cardboard, paper, wood or plastic) in or on the device.
• Do not cover the device during operation.
NOTICE – Risk of Damage to Material and Property
• The device should only be used if it has been correctly assembled! Before each use, check
whether the fi lter holder and the permanent fi lter are inserted correctly and whether the
water tank is fi lled correctly!
• Switch off the device and pull the mains plug out of the plug socket if an error occurs during
operation or before a thunderstorm.
• Never pull or carry the device by the connecting cable. When you pull it out of the plug sock-
et, always pull on the mains plug and never the mains cable!
• Protect the device from other heat sources, naked fl ames, sub-zero temperatures, persistent
moisture, wet conditions and impacts.
• Use only original accessories from the manufacturer in order to guarantee that there is no
interference that may prevent the device from working and to avoid possible damage.

Before Initial Use

1. Remove all packaging materials and any possible protective fi lms and transport protection.
Never remove the rating plate and any possible warnings.
2. Wipe the device with a clean, damp cloth. Clean the thermal jug (6),
the fi lter holder (9) and the permanent fi lter (8) as well as the measuring spoon (7) with a
mild detergent and warm water.
3. Set up and connect the device (see the "Setting Up and Connecting the Device" chapter).
4. Before you fi rst enjoy a coffee, we recommend that you carry out a trial run to remove any
possible production residues on the device and in the water system. To do this, follow the
instructions in the "Handling and Operation" and "Preparation" chapters.
When the device is fi rst used, production-related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
5. Repeat this process twice. Do not drink this coffee!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 21 02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 21
EN
06.12.2019 11:35:01 06.12.2019 11:35:01